Description
Diagnosis procedure
1.Check ambient sensor signal circuit
Check the ambient sensor signal circuit. Refer to hac-63, "diagnosis procedure" (with auto a/c) or mwi-62, "diagnosis procedure" (without auto a/c).
Is the inspection result normal? Yes >> go to 2.
No >> repair or replace harness or connector.
2.Check ambient sensor
Check the ambient sensor. Refer to mwi-62, "component inspection".
Is the inspection result normal? Yes >> replace combination meter. Refer to mwi-77, "removal and installation".
No >> replace ambient sensor. Refer to hac-106, "removal and installation".
The parking brake release warning continues displaying, or does not display
The low washer fluid warning lamp does not turn on or offBrake pedal
Adjustment
BRAKE PEDAL HEIGHT
Remove instrument lower panel LH. Refer to IP-21, "Removal and
Installation".
Disconnect the harness connectors from the brake pedal position switch
(if equipped) and the stop lamp
switch.
Turn the stop lamp switch and brake pedal position swi ...
Sensor power supply 2 circuit
Description
ECM supplies a voltage of 5.0 V to some of the sensors systematically divided
into 2 groups, respectively.
Accordingly, when a short circuit develops in a sensor power source, a
malfunction may occur simultaneously
in the sensors belonging to the same group as the shorted-circui ...
OIL PAN
Exploded View
Transaxle assembly
Oil pan gasket
Magnet
Oil pan
Overflow tube
Drain plug gasket
Drain plug
Oil pan fitting bolt
: Always replace after every
disassembly.
: NВ·m (kg-m, ft-lb)
: NВ·m (kg-m, it-lb)
Removal and Installation
REMOVAL
Remove the en ...