Nissan Sentra manuals

Nissan Sentra Service Manual: Removal and installation

Eco mode switch

Removal and installation

Removal

  1. Remove instrument lower panel LH. Refer to IP-21, "Removal and Installation".
  2. Remove ECO mode switch.

Installation

Installation is in the reverse order of removal.

Symptom diagnosis
The eco mode indicator lamp does not turn on Description The ECO mode indicator lamp does not turn ON when the ECO mode switch is operated. Diagnosis Procedure 1.Perform combination meter on boa ...

Sport mode (m/t)
...

Other materials:

Parking lamp circuit
Description The ipdm e/r (intelligent power distribution module engine room) controls the tail lamp relay based on inputs from the bcm over the can communication lines. When the tail lamp relay is energized, power flows through fuse 36, located in the ipdm e/r. Power then flows to the front ...

Abs branch line circuit
Diagnosis procedure 1.Check connector Turn the ignition switch OFF. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the abs actuator and electric unit (control unit) for damage, bend and loose connection (unit side and connector side). ...

Diagnosis system (ipdm e/r) (without intelligent key system)
Diagnosis Description AUTO ACTIVE TEST Description In auto active test, the IPDM E/R sends a drive signal to the following systems to check their operation. Front wiper (LO, HI) Parking lamp License plate lamp Tail lamp Front fog lamp (if equipped) Headlamp (LO, HI) A/C compress ...

В© 2014-2026 Copyright www.nisentra.com