Nissan Sentra Service Manual: Removal and installation
Ipdm e/r
Exploded view
- Ipdm e/r
- Ipdm e/r cover a
- Ipdm e/r cover b
Removal and installation
Caution:
Ipdm e/r integrated relays are not serviceable and must not be removed from unit.
Removal
- Remove inlet air duct (upper). Refer to em-25, "removal and installation".
- Remove battery. Refer to pg-50, "removal and installation (battery)".
- Release pawls (a) on ipdm e/r cover and remove ipdm e/r (1) from ipdm e/r cover b (2).
- Disconnect harness connector and then remove ipdm e/r.
- Remove engine room harness from ipdm e/r cover b.
- Remove ipdm e/r cover b nuts (a).
- Insert a suitable tool (A) between IPDM E/R cover A (1) and IPDM E/R cover B (2), disengage pawls, and remove IPDM E/R cover A.
- Remove ipdm e/r cover b.
Installation
Installation is in the reverse order of removal.
Dtc/circuit diagnosis
U1000 can comm circuit
Description
Refer to LAN-7, "CAN COMMUNICATION SYSTEM : System Description".
Dtc logic
DTC DETECTION LOGIC
CONSULT Display
DTC Detection Condition
...
Other materials:
Loading tips
The GVW must not exceed GVWR
or GAWR as specified on the
F.M.V.S.S./C.M.V.S.S. certification
label.
Do not load the front and rear axle to
the GAWR. Doing so will exceed the
GVWR.
WARNING
Properly secure all cargo with
ropes or straps to help prevent it
from slid ...
Heating and cooling unit assembly
Exploded view
With air conditioning
Defroster seal
Center ventilator seal
Upper distribution module
Side ventilator seal (LH)
Blower motor
Blower unit
Intake door motor
Power transistor
Power transistor wiring harness
Front floor duct (lh)
Vent and defroster linkage
Mo ...
Brake warning lamp
Component Function Check
1.CHECK BRAKE WARNING LAMP FUNCTION (1)
Check that brake warning lamp in combination meter turns ON for
approximately 2 seconds after ignition
switch is turned ON.
Is the inspection result normal?
YES >> GO TO 2.
NO >> Proceed to diagnosis procedure. ...
