Nissan Sentra manuals

Nissan Sentra Service Manual: Rear suspension assembly

Inspection

COMPONENT PART

Check the mounting conditions (looseness, backlash) of each component. Verify the component conditions (wear, damage) are normal.

SHOCK ABSORBER

Check the shock absorber for oil leaks or damage. Replace the components if necessary.

Periodic maintenance
...

Wheel alignment
Inspection DESCRIPTION Measure the wheel alignment under unladen conditions. NOTE: “Unladen conditions” means that fuel, engine coolant, and lubricants are full. Spare tire, jack, hand ...

Other materials:

B2268 water temp
Description The engine coolant temperature signal is transmitted from ecm to the combination meter via can communication. Dtc logic Dtc detection logic Dtc Consult Detection condition Probable malfunction location B2268 Water temp meter [b2268] Ecm continuous ...

Environmental factors influence the rate of corrosion
Moisture Accumulation of sand, dirt and water on the vehicle body underside can accelerate corrosion. Wet floor coverings will not dry completely inside the vehicle and should be removed for drying to avoid floor panel corrosion. Relative humidity Corrosion will be accelerated in areas of h ...

Precaution for Work
When removing or disassembling each component, be careful not to damage or deform it. If a component may be subject to interference, be sure to protect it with a shop cloth. When removing (disengaging) components with a screwdriver or similar tool, be sure to wrap the component with a ...

© 2014-2026 Copyright www.nisentra.com