Nissan Sentra Owners Manual: Precautions on cruise control

Nissan Sentra Owners Manual / Starting and driving / Cruise control (if so equipped) / Precautions on cruise control

ACCEL/RES switch
COAST/SET switch
CANCEL switch
ON·OFF switch

If the cruise control system malfunctions, it cancels automatically. The CRUISE indicator light in the instrument panel then blinks to warn the driver, see “Warnings/Indicator Lights and Audible Reminders” in the “Instruments and controls” section.
If the CRUISE indicator light blinks, push the cruise control ON·OFF switch off and have the system checked by a NISSAN dealer.
The CRUISE indicator light may blink when the cruise control ON·OFF switch is pushed ON while pushing the ACCEL/RES, COAST/SET, or CANCEL switch. To properly set the cruise control system, use the following procedures.

WARNING

Do not use the cruise control when driving under the following conditions:

When it is not possible to keep the vehicle at a set speed.
In heavy traffic or in traffic that varies in speed.
On winding or hilly roads.
On slippery roads (rain, snow, ice, etc.).
In very windy areas.

Doing so could cause a loss of vehicle control and result in an accident.

Cruise control (if so equipped)

...

Cruise control operations

The cruise control allows driving at a speed between 25 - 89 MPH (40 - 144 km/h) without keeping your foot on the accelerator pedal. To turn on the cruise control, push the ON·OFF switch. The C ...

Other materials:

A-bag branch line circuit
Diagnosis procedure Warning: Always observe the following items for preventing accidental activation. Before servicing, turn ignition switch off, disconnect battery negative terminal, and wait 3 minutes or more. (To discharge backup capacitor.) Never use unspecified tester or other ...

System description
Component parts Nissan vehicle immobilizer system-nats Nissan vehicle immobilizer systemnats : component parts location Bcm (view with instrument panel removed) Dongle unit (canada only) (behind instrument panel lh) Ignition switch Nats antenna amp. (Inside steering column) ...

Service
Never use electrical test equipment to check SRS circuits unless instructed to in this Service Manual. Before servicing the SRS, turn power switch OFF, disconnect battery negative terminal and wait 3 minutes or more. For approximately 3 minutes after the cables are removed, it is stil ...