Nissan Sentra manuals

Nissan Sentra Service Manual: Periodic maintenance

Symptom diagnosis
Noise, vibration and harshness (NVH) troubleshooting NVH Troubleshooting Chart Use the chart below to find the cause of the symptom. The numbers indicate the order of the inspection. If necessary, ...

Clutch pedal
Inspection and Adjustment INSPECTION The Height of Clutch Pedal Pull back the floor trim and remove front floor spacer (LH) for access to floor panel. Check that the clutch pedal height (H1 ...

Other materials:

P0420 Three way catalyst function
DTC Logic DTC DETECTION LOGIC The ECM monitors the switching frequency ratio of air fuel ratio (A/F) sensor 1 and heated oxygen sensor 2. A three way catalyst (manifold) with high oxygen storage capacity will indicate a low switching frequency of heated oxygen sensor 2. As oxygen storage c ...

Refrigerant pressure sensor
Component Function Check 1.CHECK REFRIGERANT PRESSURE SENSOR OVERALL FUNCTION Start engine and warm it up to normal operating temperature. Turn A/C switch and blower fan switch ON. Check the voltage between ECM harness connector terminals. Is the inspection result normal? YES >> ...

Brake warning lamp
Component Function Check 1.CHECK BRAKE WARNING LAMP FUNCTION (1) Check that brake warning lamp in combination meter turns ON for approximately 2 seconds after ignition switch is turned ON. Is the inspection result normal? YES >> GO TO 2. NO >> Proceed to diagnosis procedure. ...

В© 2014-2025 Copyright www.nisentra.com