Nissan Sentra Service Manual: Map lamp
Removal and installation
Removal
Lower front edge of map lamp (1) down from the headlining by releasing the metal clips, then slide forward to clear pawls at rear.
: Metal clip
Pawl
- Disconnect the harness connectors from the map lamp and remove.
Installation
Installation is in the reverse order of removal.
Bulb replacement
The map lamp led bulbs are replaced as part of the map lamp. Refer to inl-52, "removal and installation".
Vanity mirror lamp
Removal and installation
Caution:
Do not attempt to separate the vanity mirror lamp from the sun visor or
damage to the components
may occur.
Note:
The vanity mirror lamp is replaced as part o ...
Other materials:
Wiring diagram
Nvis (nissan vehicle immobilizer system-
nats)
Wiring Diagram
Vehicle security system
Wiring diagram
...
Seat belt buckle switch signal circuit
Description
Transmits a seat belt buckle switch lh (driver seat) signal to the
combination meter
Component function check
1. Check combination meter input signal
Select data monitor for meter/m&a and check the buckle sw monitor value.
YES >> Inspection End.
NO >> Refe ...
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG"
and "SEAT BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT
BELT PRE-TENSIONER”, used along
with a front seat belt, helps to reduce the risk or severity of injur ...
