Fan speed control
Press the fan control buttons
to
manually
control the fan speed.
Press the AUTO button to return to automatic control of the fan speed.
Air recirculation
Press the
air recirculation
button to recirculate
interior air inside the vehicle. The
indicator light on the button will come on.
The air recirculation cannot be activated when
the air conditioner is in the
front
defrosting
mode or the
front defrosting and
foot outlet
mode.
Fresh air intake
Press the
fresh air intake
button to draw
outside air into the passenger compartment.
The
indicator light on the button
will come
on.
Automatic intake air control
In the AUTO mode, the intake air will be controlled
automatically. To manually control the intake
air, press the
air recirculation
button.
To return to the automatic control mode, press
and hold
the air recirculation
button or
press and hold
the fresh air
intake button
for about 2 seconds. The indicator lights (both air
recirculation and fresh air intake buttons) will
flash twice, and then the intake air will be controlled
automatically.
Air flow control
Pressing the MODE button manually controls air flow and selects the air outlet:
— Air flows from center and side
vents.
— Air flows from center and side
vents and foot outlets.
— Air flows mainly from foot
outlets.
— Air flows from defroster and
foot
outlets.
To turn system off
Press the OFF button.
Rear window and outside mirror (if so equipped) defroster switch
For more information about the rear window and outside mirror (if so equipped) defroster switch, see “Rear window and outside mirror (if so equipped) defroster switch” in the “Instruments and controls” section of this manual.
Automatic operation
Operating tipsDuring a call
While a call is active, the following options are
available on the screen:
“Handset”
Select this option to switch control of the
phone call over to the handset.
“Mute Mic.”
Select this option to mute the microphone.
Select again to unmute the microphone.
Red phone ( ...
A-bag branch line circuit
Diagnosis procedure
Warning:
Always observe the following items for preventing accidental
activation.
Before servicing, turn ignition switch off, disconnect battery
negative terminal, and wait 3 minutes
or more. (To discharge backup capacitor.)
Never use unspecified tester or other me ...
Engine maintenance
Drive belt
Drive belt : inspection
Alternator
Drive belt auto-tensioner
Crankshaft pulley
A/c compressor
Water pump
Drive belt
Possible use range
New drive belt range
Ndicator
Warning:
Perform this step when engine is stopped.
Check that the indicator of drive bel ...