Nissan Sentra Service Manual: Latch system for children

Nissan Sentra Service Manual / Restraints / Seat belt / Removal and installation / Latch system for children

Exploded View

LATCH bracket (RH)
LATCH bracket (LH)
Seat belt buckle anchor bracket

Removal and Installation Front

Removal and Installation

REMOVAL

Remove the rear seat cushion assembly. Refer to SE-23, "Removal and Installation - Seat Cushion Assembly"
Remove the rear seatback assembly. Refer to SE-23, "Removal and Installation - 60:40 Split Seatback".
Remove the LATCH bracket bolts and the LATCH bracket.

INSTALLATION

Installation is in the reverse order of removal.

Always perform an inspection after repair to be sure the system is functioning within specifications. Refer to SB-5, "Inspection".
Tighten the LATCH bracket bolts to specification. Refer to SB-13, "Exploded View".

Rear seat belt

Exploded View - Seat Belt Retractor Seat belt retractor (RH) Seat belt retractor (center) Seat belt retractor (LH) Front Removal and Installation - Seat Belt Retractor REMOVAL R ...

Top tether strap child restraint

Removal and Installation The top tether strap child restraint system components (1) are part of the vehicle structure and are not serviceable. ...

Other materials:

Steering gear and linkage
Inspection INSPECTION AFTER DISASSEMBLY BOOT Check boot for cracks. Replace if any damage is found. STEERING GEAR ASSEMBLY HOUSING Check steering gear assembly housing for damage and scratches. Replace if there are any abnormal conditions. OUTER SOCKET AND INNER SOCKET B ...

Dtc/circuit diagnosis
U1000 can comm Description Refer to LAN-7, "CAN COMMUNICATION SYSTEM : System Description". Dtc logic Dtc detection logic Note: U1000 can be set if a module harness was disconnected and reconnected, perhaps during a repair. Confirm that there are actual can diagnostic symptoms and ...

Main line between dlc and hvac circuit
Diagnosis procedure 1.Check harness continuity (open circuit) Turn the ignition switch off. Disconnect the battery cable from the negative terminal. Disconnect the following harness connectors. Ecm A/C auto amp. Check the continuity between the data link connector and the A/C ...