Nissan Sentra Service Manual: C1113, C1145, C1146 Yaw rate/side/decel G Sensor

Nissan Sentra Service Manual / Brakes / Brake control system / Dtc/circuit diagnosis / C1113, C1145, C1146 Yaw rate/side/decel G Sensor

DTC Logic

DTC DETECTION LOGIC

DTC	Display Item	Malfunction detected condition	Possible causes
C1113	G SENSOR	When a malfunction is detected in longitunal G sensor signal.	ABS actuator and electric unit (control unit)
C1145	YAW RATE SENSOR	When a malfunction is detected in yaw rate signal. When yaw rate signal is not continuously received for 2 seconds or more. When side G signal is not continuously received for 2 seconds or more. When decel G signal is not continuously received for 2 seconds or more.
C1146	SIDE G-SEN CIRCUIT	When a malfunction is detected in side/decel G signal.

DTC CONFIRMATION PROCEDURE

1.CHECK SELF DIAGNOSTIC RESULT

With CONSULT

Turn ignition switch OFF to ON.
Perform self diagnostic result.

Is DTC C1113, C1145 or C1146 detected? YES >> Proceed to diagnosis procedure. Refer to BRC-67, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.REPLACE ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)

Replace ABS actuator and electric unit (control unit).

>> Replace ABS actuator and electric unit (control unit). Refer to BRC-110, "Removal and Installation".

C1111 PUMP MOTOR

DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1111 PUMP MOTOR When a malfunction is detected in motor or mot ...

C1115 ABS Sensor [abnormal signal]

DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1115 ABS SENSOR [ABNORMAL SIGNAL] When difference in wheel speed betw ...

Other materials:

Intake manifold tuning system
INTAKE MANIFOLD TUNING SYSTEM : System Description SYSTEM DIAGRAM SYSTEM DESCRIPTION This system switches the length of intake air path according to the low-to-medium speed range or high speed range. Torque is increased in the low-to-medium speed range and the engine output is improved ...

Ecu diagnosis information
Bcm (body control module) List of ecu reference Moonroof motor assembly Reference value Terminal layout Physical values ...

Hvac branch line circuit
Diagnosis procedure 1.Check connector Turn the ignition switch off. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the a/c auto amp. For damage, bend and loose connection (unit side and connector side). Is the inspection result normal? ...