Nissan Sentra Service Manual: Av branch line circuit
Diagnosis Procedure
1.Check connector
- Turn the ignition switch off.
- Disconnect the battery cable from the negative terminal.
- Check the terminals and connectors of the av control unit for damage, bend and loose connection (unit side and connector side).
Is the inspection result normal? Yes >> go to 2.
No >> repair the terminal and connector.
2.Check harness for open circuit
- Disconnect the connector of av control unit.
- Check the resistance between the av control unit harness connector terminals.
- With navigation system without BOSE audio system
- With navigation system and bose audio system
Is the measurement value within the specification? Yes >> go to 3.
No >> repair the av control unit branch line.
3.Check power supply and ground circuit
Check the power supply and the ground circuit of the av control unit. Refer to the following.
- With navigation system without bose audio system: refer to av-270, "av control unit : diagnosis procedure".
- With navigation system and bose audio system: refer to av-370, "av control unit : diagnosis procedure".
Is the inspection result normal? Yes (present error)>>replace the av control unit. Refer to the following.
- With navigation system without bose audio system: refer to av-298, "removal and installation".
- With navigation system and bose audio system: refer to av-406, "removal and installation".
Yes (past error)>>error was detected in the av control unit branch line.
No >> repair the power supply and the ground circuit.
Strg branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the steering angle sensor fo ...
Hvac branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the a/c auto amp. For damage ...
Other materials:
ABS Warning lamp
Component Function Check
1.CHECK ABS WARNING LAMP FUNCTION
Check that ABS warning lamp in combination meter turns ON for
approximately 2 seconds after ignition switch
is turned ON.
Is the inspection result normal?
YES >> Inspection End.
NO >> Proceed to diagnosis procedure. ...
General Precaution
WARNING:
When replacing fuel line parts, be sure to observe the following.
Put a “CAUTION: FLAMMABLE” sign in the work area.
Be sure to work in a well ventilated area and have a CO2 fire
extinguisher.
Do not smoke while working on the fuel system. Keep open flames
and sparks ...
Vehicle Dynamic Control (VDC) off switch
The vehicle should be driven with the Vehicle
Dynamic Control (VDC) system on for most driving
conditions.
If the vehicle is stuck in mud or snow, the VDC
system reduces the engine output to reduce
wheel spin. The engine speed will be reduced
even if the accelerator is depressed to the f ...
