Nissan Sentra Service Manual: Anti-pinch inspection

Nissan Sentra Service Manual / Body exterior, doors, roof & vehicle security / Power window control system / Basic inspection / Anti-pinch inspection

Descriptio

If any of the following operations are performed, the initialization is necessary for normal operation of antipinch function.

Disconnection and connection of battery cable from negative terminal.
When power window main switch replaced.
Electric power supply to power window main switch or power window motor (driver side) is interrupted by blown fuse or disconnection and connection of the negative terminal of battery, etc.
Disconnection and connection of power window main switch harness connector.
Removal of power window motor (driver side) from regulator assembly.
Operation of regulator assembly as an independent unit.
Removal and installation of glass.
Removal and installation of door glass run.

Work Procedure

1.CHECK ANTI-PINCH FUNCTION

Fully open the door window.
Place a piece of wood near fully closed position.
Close door glass completely with AUTO-UP.
Check the following conditions.

Check that glass lowers for approximately 150 mm (5.91 in.) without pinching piece of wood and stops.
Check that glass does not rise not when operating the power window main switch while lowering.

CAUTION:

Perform initial setting when AUTO-UP operation or anti-pinch function does not operate normally.
Check that AUTO-UP operates before inspection when system initialization is performed.
Do not check with hands and other body parts because they may be pinched. Do not get pinched.

>> END

System initialization

Description If any of the following operations are performed, the initialization is necessary for normal operation of power window system. Disconnection and connection of battery cable from ne ...

Other materials:

Dtc/circuit diagnosis
Power supply and ground circuit Diagnosis Procedure Refer to LAN-7, "CAN COMMUNICATION SYSTEM : System Description". Vehicle security indicator Description DTC DETECTION LOGIC NOTE: U1000 can be set if a module harness was disconnected and reconnected, perhaps during a repair. Con ...

Body component parts
Moonroof panel assembly Roof panel assembly Front roof rail Roof rail Rear roof rail Moonroof frame assembly Hood assembly Front fender (RH, LH) Outer front door panel (RH, LH) Outer rear door panel (RH, LH) Front door assembly (RH, LH) Rear door assembly (RH, LH) Fron ...

Precaution for supplemental restraint system (SRS) "air bag" and "seat belt pre-tensioner"
The Supplemental Restraint System such as вЂњAIR BAGвЂќ and вЂњSEAT BELT PRE-TENSIONERвЂќ, used along with a front seat belt, helps to reduce the risk or severity of injury to the driver and front passenger for certain types of collision. Information necessary to service the system ...