Nissan Sentra Service Manual: With intelligent key system
- Precaution
- Preparation
- System description
- Diagnosis system (BCM)
- ECU diagnosis information
- Wiring diagram
- Basic inspection
- DTC/circuit diagnosis
- Power supply and ground circuit
- Door lock actuator
- Door lock and unlock switch
- Symptom diagnosis
- Removal and installation
- Front door
- Rear door
- Door handle
- Trunk lid
- Inside key antenna
Door & lock
...
Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT
BELT PRE-TENSIONER"
The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE- ...
Other materials:
Dtc/circuit diagnosis
U1000 can comm circuit
Description
Refer to lan-7, "can communication system : system description".
DTC Logic
Dtc detection logic
Note:
U1000 can be set if a module harness was disconnected and reconnected,
perhaps during a repair. Confirm
that there are actual can diagnostic sym ...
Front door
Door assembly
Door assembly : removal and installation
CAUTION:
Use two people when removing or installing the front door assembly
due to its heavy weight.
When removing and installing front door assembly, support front
door using a suitable tool.
Do not use air tools or electric to ...
Condenser
Removal and installation
Removal
Remove the rear pillar finisher. Refer to INT-29, "REAR PILLAR FINISHER
: Removal and Installation".
Disconnect the harness connectors (1), remove the condenser
bolt (A) and the condenser (2).
: Front
Installation
Installation is in th ...
