Nissan Sentra Service Manual: Water pump
Exploded View
- Gasket
- Water pump
WARNING:
Do not remove the radiator cap when the engine is hot. Serious burns could occur from high-pressure engine coolant escaping from the radiator. Wrap a thick cloth around the cap. Slowly push down and turn it a quarter turn to allow built-up pressure to escape. Carefully remove the cap by pushing it down and turning it all the way.
CAUTION:
- When removing water pump assembly, be careful not to get engine coolant on drive belt
- Water pump cannot be disassembled and should be replaced as a unit.
- After installing water pump, connect hose and clamp securely, then check for leaks using radiator cap tester.
NOTE:
When removing components such as hoses, tubes/lines, etc., cap or plug openings to prevent fluid from spilling.
Removal and Installation
REMOVAL
- Disconnect the negative battery terminal. Refer to PG-52, "Removal and Installation".
- Remove fan shroud and motor assembly. Refer to CO-17, "Removal and Installation".
CAUTION:
- Perform this step when the engine is cold.
- Do not spill engine coolant on the drive belt.
- Partially remove front fender protector (RH). Refer to EXT-27, "FENDER PROTECTOR : Exploded View".
- Remove drive belt. Refer to EM-15, "Removal and Installation".
- Remove generator. Refer to CHG-29, "Removal and Installation".
- Remove water pump bolts, then remove water pump and gasket.
- Engine coolant will leak from cylinder block, so have a receptacle ready below.
CAUTION:
- Handle water pump vane so that it does not contact any other parts.
- Water pump cannot be disassembled and should be replaced as an assembly.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
Do not reuse gasket.
Cooling fan
Component
Fan shroud and motor assembly
WARNING:
Do not remove the radiator cap when the engine is hot. Serious burns
could occur from high-pressure
engine coolant escaping from the ra ...
Thermostat and thermostat housing
Exploded View
Thermostat housing
Gasket
Rubber ring
Thermostat
Water inlet
Clamp
Radiator hose (upper)
To radiator
WARNING:
Do not remove the radiator cap when the engin ...
Other materials:
Side window glass
Components
Side window glass
Spacer
Headlining
Rear body pillar
Rear pillar finisher
Rear door weatherstrip
Primer area
Adhesive
7 mm (0.3 in)
12 mm (0.5 in)
Removal and Installation
REMOVAL
Remove the rear pillar finisher. Refer to INT-29, "REAR PILLAR FIN ...
Seats
WARNING
Do not ride in a moving vehicle when
the seatback is reclined. This can be
dangerous. The shoulder belt will not
be against your body. In an accident,
you could be thrown into it and receive
neck or other serious injuries. You
could also slide under the ...
Ignition switch (if so equipped)
WARNING
Never remove or turn the key to the
LOCK position while driving. The steering
wheel will lock (for models with a
steering lock mechanism). This may
cause the driver to lose control of the
vehicle and could result in serious vehicle
damage or personal injury ...
