Nissan Sentra Service Manual: Washer motor circuit
Diagnosis Procedure
Regarding Wiring Diagram information, refer to WW-24, "Wiring Diagram - With Intelligent Key" or WW-29, "Wiring Diagram - Without Intelligent Key".
1. Check front washer motor fuse
- Turn the ignition switch OFF.
- Check that the following fuse is not blown.
Is the fuse blown? YES >> Replace the blown fuse after repairing the affected circuit.
NO >> GO TO 2.
2. Check front washer motor power supply
- Disconnect front washer motor.
- Turn ignition switch on.
- Check voltage between front washer motor harness connector e8 and ground.
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace the harness or connectors.
3. Check front washer motor circuit continuity
- Turn the ignition switch OFF.
- Disconnect combination switch (wiper and washer switch).
- Check continuity between combination switch (wiper and washer switch) harness connector m28 and front washer motor e8.
Is the inspection result normal? Yes >> go to 4.
No >> repair or replace the harness or connectors.
4. Check wiper and washer switch ground circuit
Check continuity between combination switch (wiper and washer switch) harness connector m28 and ground.
Is the inspection result normal? Yes >> go to 5.
No >> repair or replace the harness or connectors.
5. Check wiper and washer switch
Check wiper and washer switch. Refer to WW-45, "Component Inspection".
Is the inspection result normal? YES >> Replace front washer motor. Refer to WW-62, "Removal and Installation".
NO >> Replace wiper and washer switch. Refer to WW-63, "Removal and Installation".
Front wiper motor ground circuit
Diagnosis procedure
Regarding Wiring Diagram information, refer to WW-24, "Wiring Diagram - With
Intelligent Key" or WW-29,
"Wiring Diagram - Without Intelligent Key".
1.Check ...
Washer switch
Description
Washer switch is integrated with combination switch (wiper and washer
switch).
Combination switch (wiper and washer switch) supplies ground and fuse #
6 supplies power for the ...
Other materials:
Doors
When the doors are locked using one of the
following methods, the doors cannot be opened
using the inside or outside door handles. The
doors must be unlocked to open the doors.
WARNING
Always have the doors locked while
driving. Along with the use of seat belts,
this provides ...
Approach warning (vehicle-to-vehicle distance control mode) - Dynamic radar cruise
control
When your vehicle is too close to
a vehicle ahead, and sufficient
automatic deceleration via the
cruise control is not possible, the
display will flash and the buzzer
will sound to alert the driver. An
example of this would be if
another driver cuts in front of you
while you are following a ...
P0197, P0198 EOTSensor
DTC Logic
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P0197
EOT SEN/CIRC
(Engine oil temperature
sensor circuit low)
An excessively low voltage from the engine
oil temperature sensor ...
