To help prevent the vehicle from moving unexpectedly by erroneous operation of the Intelligent Key or to help prevent the vehicle from being stolen, a chime or buzzer sounds from inside and outside the vehicle and a warning light comes on in the instrument panel.
When a chime or beep sounds or the warning light comes on, be sure to check the vehicle and the Intelligent Key.
Audible reminder and warning when locking the doors
When the chime or buzzer sounds from inside and outside the vehicle, check for the following:
Audible reminder and warning when the engine stops
When the P position selecting warning light
(
) in the instrument panel
blinks in red:
When the chime sounds intermittently:
If the chime sounds continuously when the driver’s door is opened, check the following:
Alarm and warning when the engine starts
When the Intelligent Key system warning light
(
) blinks red and the outside
buzzer
sounds, make sure the Intelligent Key is inside the
vehicle.
Warning for low battery power
When the Intelligent Key battery is low, the Intelligent
Key system warning light (
) will
blink
green for about 30 seconds after the ignition
switch is placed in the ON position. This warning
is to let you know that the battery of the Intelligent
Key will run down soon. Replace it with a new
one. Refer to “Battery replacement” in the “Maintenance
and do-it-yourself” section.
NISSAN recommends replacing the battery at a NISSAN dealer.
Preventing the Intelligent Key from being left in the vehicle
If you lock all doors using the power door lock switch with the Intelligent Key in the vehicle, all of the doors unlock immediately and the buzzer will warn you when the door is closed.
Warning lights and audible reminders
Troubleshooting guideThe seat belt reminder warning
continues sounding, or does not
sound
Description
Seat belt reminder warning does not sound.
Seat belt reminder warning sounds continuously.
Diagnosis procedure
1.Check seat belt warning lamp
Turn ignition switch on.
Check the operation of the seat belt warning lamp in the combination
meter.
Is the inspection ...
System description
Component parts
CVT CONTROL SYSTEM
CVT CONTROL SYSTEM : Component Parts Location
No.
Component
Function
1
ECM
Mainly transmits the following signal to TCM via CAN
communication.
Engine and CVT integrated control signal
NOTE:
General term for the c ...
Anti-pinch system does not operate normally (driver side)
Diagnosis Procedure
1.CHECK POWER WINDOW AUTO OPERATION
Check AUTO operation when anti-pinch function does not operate.
Refer to PWC-67, "Diagnosis Procedure".
Is the inspection result normal?
YES >> INSPECTION END
NO >> GO TO 2.
2.REPLACE POWER WINDOW MAIN SWITCH
...