Nissan Sentra Service Manual: Vehicle jerks during vdc/tcs/abs control
Diagnosis Procedure
1.SYMPTOM CHECK
Check if the vehicle jerks during VDC/TCS/ABS control.
Is the inspection result normal? YES >> Inspection End.
NO >> GO TO 2
2.CHECK SELF DIAGNOSTIC RESULT
Perform self diagnostic result of ABS actuator and electric unit (control unit). Refer to BRC-31, "CONSULT Function (ABS)".
Are self diagnostic results indicated? YES >> Check corresponding items, make repairs, and perform ABS actuator and electric unit (control unit) self diagnostic result again. Refer to BRC-31, "CONSULT Function (ABS)".
NO >> GO TO 3
3.CHECK CONNECTOR
-
Turn ignition switch OFF.
-
Disconnect ABS actuator and electric unit (control unit) connector.
-
Check terminals for deformation, disconnection, looseness, etc.
-
Securely reconnect connector and perform ABS actuator and electric unit (control unit) self diagnostic result. Refer to BRC-31, "CONSULT Function (ABS)".
Are self diagnostic results indicated? YES >> If poor contact, damage, open or short circuit of connector terminal is found, repair or replace.
NO >> GO TO 4
4.CHECK ECM AND TCM SELF DIAGNOSTIC RESULT
-
Perform ECM self diagnostic result. Refer to EC-66, "CONSULT Function".
-
Perform TCM self diagnostic result. Refer to TM-108, "CONSULT Function".
Are self diagnostic results indicated? YES >> Check the corresponding items.
-
ECM: Refer to EC-94, "DTC Index".
-
TCM: Refer to TM-126, "DTC Index".
NO >> Replace ABS actuator and electric unit (control unit). Refer to BRC-110, "Removal and Installation".
Pedal vibration or abs operation
sound occurs
Diagnosis Procedure
CAUTION:
Under the following conditions, ABS is activated and
vibration is felt when brake pedal is lightly
depressed (just place a foot on it). However, this is norma ...
Normal operating condition
Description
Symptom
Result
Slight vibrations are felt on the brake pedal and operation noises
occur when VDC, TCS or ABS is activated.
This is a normal condition
due to t ...
Other materials:
Ecu diagnosis information
BCM
Reference value
Note:
The signal tech ii tool (j-50190) can be used to perform the following
functions. Refer to the signal tech ii
user guide for additional information.
Activate and display tpms transmitter ids
Display tire pressure reported by the tpms transmitter
Read TPMS DTCs ...
TCM
Exploded View
Bracket
TCM
: Vehicle front
: NВ·m (kg-m, in-lb)
Removal and Installation
CAUTION:
When replacing TCM, note the “CVTF DETERIORATION DATE” value
displayed on CONSULT “CONFORM
CVTF DETERIORTN” in MAINTENANCE BOOKLET, before start the opera ...
B14XX Air bag diagnosis sensor unit
Description
DTC B14XX AIR BAG DIAGNOSIS SENSOR UNIT
The air bag diagnosis sensor unit will run self diagnostics when the ignition
switch is turned ON. It has the
potential to set many diagnostic trouble codes which will conform to the B14XX
format, but will not match any
other SRS diagnosti ...
