Nissan Sentra Service Manual: Vanity mirror lamp
Removal and installation
Caution:
Do not attempt to separate the vanity mirror lamp from the sun visor or damage to the components may occur.
Note:
The vanity mirror lamp is replaced as part of the sun visor. Refer to int-40, "removal and installation".
Bulb or lens replacement
Warning:
Do not touch bulb while it is lit or right after being turned off. Burning may result.
Caution:
- Do not attempt to separate the vanity mirror lamp from the sun visor or damage to the components may occur.
- Do not touch glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to bulb.
- Release the pawls on the vanity mirror lamp lens (1) using a suitable tool.
Pawl
- Remove the bulb (a) using a suitable tool.
- Install bulb to vanity mirror lamp.
- Install the vanity mirror lamp lens.
Map lamp
Removal and installation
Removal
Lower front edge of map lamp (1) down from the headlining by
releasing the metal clips, then slide forward to clear pawls at
rear.
: Metal clip
Pawl
D ...
Glove box lamp
Removal and installation
Warning:
Do not touch bulb while it is lit or right after being turned off.
Burning may result.
Caution:
Do not touch glass surface of the bulb with bare hands or allow ...
Other materials:
P0130 A/F Sensor 1
DTC Logic
DTC DETECTION LOGIC
To judge the malfunction, the diagnosis checks that the A/F signal computed
by ECM from the A/F sensor 1
signal fluctuates according to fuel feedback control.
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possi ...
Power outlet
Please use as a power supply for electronic goods that use less than
12 VDC/10 A (power consumption of 120 W).
Open the lid.
â– The power outlet can be used when
Vehicles without a smart key system:
The engine switch is in the "ACC" or "ON" position.
Vehicles with a smart key system:
Th ...
Basic inspection
Diagnosis and repair work flow
Work flow
Overall sequence
Detailed flow
1.Get information for symptom
Get the detailed information from the customer about the symptom (the
condition and the environment when
the incident/malfunction occurred) using the “diagnostic work sheet”. ( ...
