Nissan Sentra manuals

Nissan Sentra Service Manual: Unit disassembly and assembly

Front drive shaft

Front drive shaft
6M/T 6M/T : Exploded View (LH) Front drive shaft Nut retainer Cotter pin Molykote M77 Front 6M/T : Removal and Installation (LH) NOTE: When removing components such as hoses ...

6M/T
6M/T : Exploded View (LH) Circular clip Dust shield Slide joint housing Snap ring Spider assembly Boot band Boot Shaft Damper band Dynamic damper Circular clip Joint sub ...

Other materials:

Compression pressure
Inspection Warm up the engine to full operating temperature. Release fuel pressure. Refer to EC-143, "Work Procedure". Remove ignition coil and spark plug from each cylinder. Refer to EM-46, "Exploded View". Connect engine tachometer (not required in use of CONSULT). ...

Checking engine coolant level
Check the coolant level in the reservoir when the engine is cold. If the coolant level is below the MIN level B , add coolant to the MAX level A . If the reservoir is empty, check the coolant level in the radiator when the engine is cold. If there is insufficient coolant in the radiator, fi ...

DTC/circuit diagnosis
POWER SUPPLY AND GROUND CIRCUIT A/C AUTO AMP. A/C AUTO AMP. : Diagnosis Procedure Regarding Wiring Diagram information, refer to HAC-145, "Wiring Diagram" or HAC-152, "Wiring Diagram". 1.CHECK FUSE Check fuses [No. 5, 8 and 21, located in the fuse block (J/B)]. NOTE: Ref ...

В© 2014-2026 Copyright www.nisentra.com