Nissan Sentra manuals

Nissan Sentra Service Manual: Unit disassembly and assembly

TORQUE CONVERTER AND CONVERTER HOUSING OIL SEAL

Exploded View


  1. Transaxle assembly
  2. Torque converter
  3. Converter housing oil seal

Disassembly : Apply CVT Fluid


Disassembly

  1. Remove transaxle assembly.
  2. Remove torque converter.

CAUTION:

Do not damage the bushing on the inside of torque converter sleeve when removing torque converter.

  1. Remove converter housing oil seal using a suitable tool.

CAUTION:

Be careful not to scratch converter housing.

Assembly

Note the following, and install in the reverse order of removal.

CAUTION:

Dimension (A) : 13 В± 0.5 mm (0.051 В± 0.02 in)

NOTE:

Converter housing oil seal pulling direction is used as the reference.


CAUTION:

Inspection


Inspection

INSPECTION AFTER INSTALLATION

B : Scale

C : Straightedge

Dimension (A) : Refer to TM-289, "Torque Converter".

Service data and specifications (SDS)


Unit removal and installation
TRANSMISSION ASSEMBLY Exploded View Transaxle assembly O-ring CVT fluid charging pipe CVT fluid charging pipe cap Tightening must be done following the installation procedure. Re ...

Service data and specifications (SDS)
General Specification CAUTION: Use only Genuine NISSAN CVT Fluid NS-3. Never mix with other fluid. Use only Genuine NISSAN CVT Fluid NS-3. Using transmission fluid other than Genuine ...

Other materials:

USB interface (models with Navigation System)
Connecting a device to the USB input jack WARNINGDo not connect, disconnect, or operate the USB device while driving. Doing so can be a distraction. If distracted you could lose control of your vehicle and cause an accident or serious injury. CAUTION Do not force t ...

System description
Component parts Component parts location Ipdm e/r System Relay control system Relay control system : system diagram System diagram Relay control system : system description Ipdm e/r activates the internal control circuit to perform the relay on-off control according to the inp ...

Mixture ratio self-learning value clear
Description This describes how to erase the mixture ratio self-learning value. For the actual procedure, follow the instructions in “Diagnosis Procedure”. Work Procedure 1.START With CONSULT Start engine and warm it up to normal operating temperature. Select “SELF-LEARNI ...

© 2014-2024 Copyright www.nisentra.com