Nissan Sentra Service Manual: Unit disassembly and assembly

Engine assembly CVT

CVT : Exploded View Washer Upper torque rod (RH) Engine mounting insulator (RH) Engine mounting insulator (LH) Rear torque rod bracket Rear torque rod CVT : Removal and Installati ...

Flywheel

Exploded View Flywheel Removal and Installation REMOVAL Remove the engine and the transaxle assembly from the vehicle, and separate the transaxle from the engine. Refer to TM-28, ...

Other materials:

Keyfob (if so equipped)
Replace the battery in the keyfob as follows: Remove the screw A . Insert a small screwdriver into the slit of the corner B and twist it to separate the upper part from the lower part. Use a cloth to protect the casing. Replace the battery with a new one. Do not touch the int ...

C1704, C1705, C1706, C1707 Low tire pressure
DTC Logic NOTE: The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information. Activate and display TPMS transmitter IDs Display tire pressure reported by the TPMS transmitter Read TPMS DTCs Register ...

Compression pressure
Inspection Warm up the engine to full operating temperature. Release fuel pressure. Refer to EC-143, "Work Procedure". Remove ignition coil and spark plug from each cylinder. Refer to EM-46, "Exploded View". Connect engine tachometer (not required in use of CONSULT). ...