Description
Unbalance steering wheel turning force and return between right and left.
Diagnosis Procedure
1.CHECK THE ILLUMINATION OF THE EPS WARNING LAMP
Check the EPS warning lamp while engine is running.
Does the EPS warning lamp turn OFF? YES >> GO TO 2.
NO >> Refer to STC-33, "Diagnosis Procedure".
2.CHECK WHEEL ALIGNMENT
Check the wheel alignment. Refer to FSU-6, "Inspection".
Perform EPS self-diagnosis.
Is the inspection result normal? YES >> GO TO 3.
NO >> Adjustment of wheel alignment. Refer to FSU-6, "Inspection".
3.Check EPS control unit signal
With CONSULT
Start the engine.
CAUTION:
Never drive the vehicle.
Turn steering wheel from full left stop to full right stop.
Select DATA MONITOR of EPS and select TORQUE SENSOR.
Perform the torque sensor inspection.
Is the inspection result normal? YES >> GO TO 5.
NO >> GO TO 4.
4.CHECK EPS MOTOR
Perform the trouble diagnosis of EPS motor. Refer to STC-27, "Diagnosis Procedure".
Is the inspection result normal? YES >> GO TO 5.
NO >> Repair or replace the specific malfunctioning part.
5.CHECK STEERING WHEEL TURNING FORCE
Check the steering wheel turning force. Refer to ST-5, "Inspection".
Is the inspection result normal? YES >> Inspection End.
NO >> Check the steering wheel turning force for mechanical malfunction. Refer to ST-5, "Inspection".
Changing a flat tire
If you have a flat tire, follow the instructions below:
Stopping the vehicle
Safely move the vehicle off the road and
away from traffic.
Turn on the hazard warning flashers.
Park on a level surface and apply the parking
brake. Shift the manual transmission into R
(Reverse), or the CVT ...
General Precaution
WARNING:
When replacing fuel line parts, be sure to observe the following.
Put a “CAUTION: FLAMMABLE” sign in the work area.
Be sure to work in a well ventilated area and have a CO2 fire
extinguisher.
Do not smoke while working on the fuel system. Keep open flames
and sparks ...
P0744 Torque converter
DTC Logic
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
Possible causes
P0744
TORQUE CONVERTER
(Torque converter clutch circuit
intermittent)
The torque converter slip speed is at or above
a set value (40 ...