Description
Initial diagnosis of combination meter.
Dtc logic
Dtc detection logic
Dtc | Display contents of consult | Detection condition | Possible malfunction |
U1010 | CONTROL UNIT (CAN) [U1010] | When detecting error during the initial diagnosis of the can controller of combination meter. | Combination meter |
Diagnosis procedure
1.Replace combination meter
When dtc u1010 is detected, replace combination meter. Refer to mwi-77, "removal and installation".
>> Inspection end.
Control buttons
The control buttons for the Bluetooth® Hands-
Free Phone System are located on the steering
wheel.
PHONE/SEND
Press the button to initiate
a VR session or answer an incoming
call.
You can also use the button
to interrupt the system feedback
and give a command at once. See
“List of ...
Multiport fuel injection system
MULTIPORT FUEL INJECTION SYSTEM : System
Description
SYSTEM DIAGRAM
*1: ECM determines the start signal status by the signals of engine speed and
battery voltage.
*2: M/T models
*3: CVT models
*4: This sensor is not used to control the engine system under normal
conditions.
SYSTEM DES ...
Filament
Inspection and Repair
Inspection
When measuring voltage, wrap tin foil around the top of the negative
probe. Then press the foil against the wire with your finger.
Attach probe circuit tester (in Volt range) to middle portion of
each filament.
If a filament is burned out ...