Nissan Sentra Service Manual: U1000 can comm circuit
Dtc logic
Dtc detection logic
| Dtc | Consult | Detection condition | Possible malfunction location |
| U1000 | Can comm circ [u1000] | When combination meter is not receiving can communication signals for 2 seconds or more. | Combination meter |
Diagnosis procedure
1.Check can communication
Select self-diag results mode for meter/m&a with consult.
>> Go to lan system. Refer to lan-16, "trouble diagnosis flow chart".
U1010 control unit (can)
Description
Initial diagnosis of combination meter.
Dtc logic
Dtc detection logic
Dtc
Display contents of consult
Detection condition
Possible malfunction
U1010
CONTRO ...
Other materials:
Precaution for Work
When removing or disassembling each component, be careful not to damage
or deform it. If a component
may be subject to interference, be sure to protect it with a shop cloth.
When removing (disengaging) components with a screwdriver or similar
tool, be sure to wrap the component
with a ...
Engine room cover
Exploded View
Engine room cover
Mounting rubber (Black)
Mounting rubber (Gray)
Removal and Installation
REMOVAL
CAUTION:
Do not damage or scratch engine room cover when installing or removing.
Remove engine room cover by pulling straight up to release mounting rubber.
INSTALLATI ...
Service
Never use electrical test equipment to check SRS circuits unless
instructed to in this Service Manual.
Before servicing the SRS, turn power switch OFF, disconnect battery
negative terminal and wait 3 minutes
or more.
For approximately 3 minutes after the cables are removed, it is stil ...
