Nissan Sentra Service Manual: Trunk room trim
Exploded View
- Trunk floor trim
- Trunk front floor spacer (LH)
- Trunk side finisher (LH)
- Reflector box assembly*
- Trunk rear plate
- Trunk side finisher (RH)
- Trunk front floor spacer (RH)
Clip
Pawl
Trunk rear plate
TRUNK REAR PLATE : Removal and Installation
REMOVAL
- Remove trunk floor trim.
- Remove clips (A).
- Release trunk rear plate pawls as shown.
Pawl
- Remove trunk rear plate.
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
When installing, check that clips and pawls are accurately aligned with the holes on body panel, then press in.
Trunk side finisher
TRUNK SIDE FINISHER : Removal and Installation
REMOVAL
- Remove trunk rear plate. Refer to INT-42, "TRUNK REAR PLATE : Removal and Installation".
- Apply protective tape (A) to protect the component from damage as shown.
- Release trunk side finisher clips using a suitable tool (A).
: Clip
- Remove trunk side finisher clips (A) and the trunk side finisher (1).
: Clip
INSTALLATION
Installation is in the reverse order of removal.
CAUTION:
- Insert rear end of trunk side finisher into trunk weather strip.
- When installing, check that clips are accurately aligned with the holes on body panel, then press in.
Headlining
Exploded View
STANDARD ROOF
Headlining
Assist grip
Map lamp bracket
Sun visor (RH)
Sun visor cover
Sun visor holder
Map lamp
Sun visor (LH)
Interior room lamp
Assist grip cap ...
Trunk lid trim
Exploded View
Trunk lid finisher
Front
Removal and Installation
REMOVAL
Remove trunk lid finisher clips (A) and trunk lid finisher.
INSTALLATION
Installation is in the reverse ord ...
Other materials:
P1078 EVT Control position sensor
DTC Logic
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P1078
EXH TIM SEN/CIRC-B1
(Exhaust valve timing control
position sensor circuit
bank 1)
An excessively high or low voltage from
...
Electrical load signal
Description
The electrical load signal (Headlamp switch signal, rear window defogger
switch signal, etc.) is transferred via
the CAN communication line.
Component Function Check
1.CHECK REAR WINDOW DEFOGGER SWITCH FUNCTION
With CONSULT
Turn ignition switch ON.
Select “DATA MONITORР...
Ecu diagnosis information
BCM
Reference value
Note:
The signal tech ii tool (j-50190) can be used to perform the following
functions. Refer to the signal tech ii
user guide for additional information.
Activate and display tpms transmitter ids
Display tire pressure reported by the tpms transmitter
Read TPMS DTCs ...
