Nissan Sentra Service Manual: Trunk room lamp
Removal and Installation
Warning:
Do not touch bulb while it is lit or right after being turned off. Burning may result.
Caution:
Do not touch glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to bulb.
- Release the tab (b) to open the lens.
: Front
- Remove the trunk room bulb (2).
- Release tab (c), then pull trunk room lamp (1) down to remove.
- Disconnect the harness connector (a) from the trunk room lamp.
Installation
Installation is in the reverse order of removal.
Bulb Replacement
Warning:
Do not touch bulb while it is lit or right after being turned off. Burning may result.
Caution:
Do not touch glass surface of the bulb with bare hands or allow oil or grease to get on it to prevent damage to bulb.
- Release the tab to open the lens.
- Remove bulb from trunk room lamp.
- Install bulb to trunk room lamp.
- Close lens.
Interior room lamp
Removal and installation
Removal
Insert a suitable tool into the gap between the headlining and the
interior room lamp and release the interior
room lamp.
Disconnect the harness connector ...
Illumination control switch
Removal and installation
Removal
Remove instrument finisher d. Refer to ip-14, "exploded view".
Remove the illumination control switch (1) from the switch carrier
(2) using suitable ...
Other materials:
Headlight control switch
Type A
Type B
Lighting
When turning the switch to the
position,
the front parking, tail, license plate and
instrument panel lights come on.
When turning the switch to the
position,
the headlights come on and all the other
lights remain on.
Headlight Type B is equipped w ...
P2100, P2103 Throttle control motorrelay
DTC Logic
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P2100
ETC MOT PWR-B1
(Throttle actuator “A”
control motor circuit/
open)
ECM detects a voltage of power source for
t ...
Wiring diagram
BCM
Wiring diagram
...
