Nissan Sentra manuals

Nissan Sentra Service Manual: Transaxle side

TRANSAXLE SIDE : Removal and Installation

Remove boot after drive shaft is removed from the vehicle.

For drive shaft removal and installation, follow the instructions bellow.

For drive shaft disassembly and assembly.

Inspection

INSPECTION AFTER INSTALLATION

  1. Check the wheel sensor harness to be sure the connectors are fully seated.
  2. Check the wheel alignment. Refer to FSU-6, "Inspection".
Wheel side
WHEEL SIDE : Removal and Installation REMOVAL Remove the wheel and tire using power tool. Refer to WT-47, "Exploded View". Remove the brake caliper torque member bolts, leaving the ...

Front drive shaft
6M/T 6M/T : Exploded View (LH) Front drive shaft Nut retainer Cotter pin Molykote M77 Front 6M/T : Removal and Installation (LH) NOTE: When removing components such as hoses ...

Other materials:

Timing chain
Exploded View Timing chain slack guide Timing chain tensioner Timing chain Oil pump drive chain Crankshaft sprocket Crankshaft key Oil pump sprocket Front cover O-ring O-ring Valve timing control solenoid valve cover O-ring Valve timing control solenoid valve (EXH) ...

ABS Warning lamp
Component Function Check 1.CHECK ABS WARNING LAMP FUNCTION Check that ABS warning lamp in combination meter turns ON for approximately 2 seconds after ignition switch is turned ON. Is the inspection result normal? YES >> Inspection End. NO >> Proceed to diagnosis procedure. ...

How to use this manual
How to use this section Information “Can” of lan section describes information peculiar to a vehicle and inspection procedures. For trouble diagnosis procedure, refer to lan-16, "trouble diagnosis flow chart" of “can fundamental”. Abbreviation list Unit ...

© 2014-2024 Copyright www.nisentra.com