Description
If any of the following malfunctions is found for the steering switch (meter control switch) operation.
Diagnosis procedure
1.Check steering switch signal circuit
Check the steering switch signal circuit. Refer to MWI-55, "Diagnosis Procedure".
Is the inspection result normal? YES >> GO TO 2.
NO >> Repair harness or connector.
2.Check steering switch (meter control switch)
Check the steering switch. Refer to MWI-55, "Component Inspection".
Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-77, "Removal and Installation".
NG >> Replace steering switch. Refer to MWI-79, "Removal and Installation".
The fuel gauge indicator does not operate
The illumination control switch is inoperativeL terminal circuit (open)
Description
The “L” terminal circuit controls the charge warning lamp. The charge warning
lamp turns ON when the ignition
switch is set to ON or START. When the generator is providing sufficient voltage
with the engine running,
the charge warning lamp turns OFF. If the charge warnin ...
Wiring diagram
Tire pressure monitoring system
With intelligent key
WITH INTELLIGENT KEY : Wiring Diagram
Without intelligent key
WITHOUT INTELLIGENT KEY : Wiring Diagram
...
Power supply and ground circuit
Combination meter
COMBINATION METER : Diagnosis Procedure
Regarding Wiring Diagram information, refer to MWI-28, "Wiring Diagram".
1.Check fuses
Check that the following fuses are not blown.
Is the fuse blown?
Yes >> replace the blown fuse after repairing the affected circu ...