Description
Diagnosis procedure
1.Check seat belt warning lamp
Is the inspection result normal? Yes >> replace combination meter. Refer to mwi-77, "removal and installation".
No >> go to 2.
2.Check seat belt buckle switch (lh) signal circuit
Check the seat belt buckle switch (lh) circuit. Refer to wcs-29, "diagnosis procedure".
Is the inspection result normal? Yes >> go to 3.
No >> repair or replace harness or connector.
3.Check seat belt buckle switch (lh)
Check the seat belt buckle switch (LH). Refer to WCS-30, "Component Inspection".
Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-77, "Removal and Installation".
NO >> Replace seat belt buckle (LH). Refer to SR-32, "Removal and Installation".
P0444, P0445 EVAP Canister purge volume control solenoid valve
DTC Logic
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P0444
PURG VOLUME CONT/V
(Evaporative emission system
purge control valve circuit open)
An excessively low voltage signal is sent to ...
Power generation voltage variable control system operation inspection
Diagnosis Procedure
Regarding wiring diagram information. Refer to chg-9, "wiring diagram".
Caution:
When performing this inspection, always use a charged battery that has
completed the battery inspection.
(When the charging rate of the battery is low, the response speed of the vol ...
Hvac branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal
Check the terminals and connectors of the a/c auto amp. For damage, bend
and loose connection (unit
side and connector side).
Is the inspection result normal?
...