Description
Diagnosis procedure
1.Check washer fluid level switch signal circuit
Check the washer fluid level switch signal circuit. Refer to mwi-65, "diagnosis procedure".
Is the inspection result normal? Yes >> go to 2.
No >> repair or replace harness or connector.
2.Check washer fluid level switch
Check for the washer fluid level switch. Refer to mwi-65, "component inspection".
Is the inspection result normal? Yes >> replace combination meter. Refer to mwi-77, "removal and installation" no >> replace washer fluid level switch. Refer to ww-53, "removal and installation".
P2100, P2103 Throttle control motorrelay
DTC Logic
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible cause
P2100
ETC MOT PWR-B1
(Throttle actuator “A”
control motor circuit/
open)
ECM detects a voltage of power source for
t ...
P0300, P0301, P0302, P0303, P0304 Misfire
DTC Logic
DTC DETECTION LOGIC
When a misfire occurs, engine speed will fluctuate. If the engine speed
fluctuates enough to cause the crankshaft
position (CKP) sensor (POS) signal to vary, ECM can determine that a misfire is
occurring.
Sensor
Input signal to ECM
ECM function
...
Removal and installation
Audio unit
Exploded view
Audio unit
Audio unit bracket (LH)
Audio unit bracket (rh)
Removal and installation
Removal
Disconnect the negative battery terminal. Refer to pg-50, "removal and
installation (battery)".
Remove cluster lid c lower. Refer to ip-20, "re ...