Description
Light reminder warning chime does not sound even though headlamp is illuminated.
Diagnosis procedure
1.Check combination meter input signal
Select the data monitor for the meter/m&a and check the buzzer monitor value.

Is the inspection result normal? Yes >> replace combination meter. Refer to mwi-77, "removal and installation".
No >> go to 2.
2.Check front door switch lh signal circuit
Check the front door switch lh signal circuit. Refer to dlk-102, "diagnosis procedure" (with intelligent key system) or dlk-253, "diagnosis procedure" (without intelligent key system).
Is the inspection result normal? Yes >> go to 3.
No >> repair or replace harness or connector.
3.Check front door switch lh
Check front door switch lh. Refer to dlk-103, "component inspection" (with intelligent key system) or dlk- 255, "component inspection" (without intelligent key system).
Is the inspection result normal? Yes >> replace the bcm. Refer to bcs-73, "removal and installation" (with intelligent key system) or bcs-126, "removal and installation" (without intelligent key system).
No >> replace the front door switch lh. Refer to dlk-194, "removal and installation" (with intelligent key system) or dlk-341, "removal and installation" (without intelligent key system).
The seat belt reminder warning
continues sounding, or does not
sound
The key warning does not sound
(without intelligent key)System description
Component parts
Component parts location
Front tweeter LH
GPS antenna
Steering switches
AV control unit
Front tweeter RH
Microphone
Front door speaker LH
Front door speaker RH
Rear door speaker LH
Rear door speaker RH
Rear woofer RH
Rear woofer LH
Antenna amp
Satel ...
Control panel buttons — color screen with Navigation System (if so equipped)
WARNING
Positioning of the heating or air conditioning
controls and display controls
should not be done while driving in order
that full attention may be given to
the driving operation.
Do not disassemble or modify this system.
If you do, it may result in acciden ...
Fuel gauge
NOTE:
The ignition switch must be placed in the
ON position for the gauge to give a reading.
The gauge indicates the approximate fuel level
in the tank.
The gauge may move slightly during braking,
turning, acceleration, or going up or down hills.
The low fuel warning light comes on when ...