Nissan Sentra Service Manual: The key warning does not sound (without intelligent key)
Description
The key warning chime does not sound, when all of the following conditions are fulfilled.
- Key inserted into the key cylinder (key switch signal on).
- Ignition switch is in acc or off (ignition switch signal off).
- Driver side door is open (driver side door switch on)
Diagnosis procedure
1.Check bcm input signal
- Connect CONSULT
- Select the data monitor of bcm (buzzer) and check the key on sw monitor value. Refer to bcs- 88, "buzzer : consult function (bcm - buzzer)".
Is the inspection result normal? Yes >> replace the bcm. Refer to bcs-73, "removal and installation" (with intelligent key system) or bcs-126, "removal and installation" (without intelligent key system).
No >> go to 2.
2.Check key switch signal circuit
Check the key switch signal circuit. Refer to dlk-262, "diagnosis procedure".
Is the inspection result normal? Yes >> replace the bcm. Refer to bcs-73, "removal and installation" (with intelligent key system) or bcs-126, "removal and installation" (without intelligent key system).
No >> check applicable parts, and repair or replace corresponding parts.
The light reminder warning does
not sound
Description
Light reminder warning chime does not sound even though headlamp is
illuminated.
Diagnosis procedure
1.Check combination meter input signal
Select the data monitor for the meter/m&am ...
Other materials:
Chassis and body maintenance
In-cabin microfilter
In-cabin microfilter : removal and installation
REMOVAL
Remove the in-cabin microfilter cover.
CAUTION:
Before removing the in-cabin microfilter cover, let the vehicle rest
for at least 30 minutes.
Release the filter cover tab (A), then pull the bottom of the in- ...
The seat belt reminder warning
continues sounding, or does not
sound
Description
Seat belt reminder warning does not sound.
Seat belt reminder warning sounds continuously.
Diagnosis procedure
1.Check seat belt warning lamp
Turn ignition switch on.
Check the operation of the seat belt warning lamp in the combination
meter.
Is the inspection ...
P0999 Shift solenoid F
DTC Logic
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
Possible causes
P0999
SHIFT SOLENOID F
(Shift Solenoid F Control Circuit
High)
The TCM low brake solenoid valve current
monitor reading is 200 mA or ...
