Description
If any of the following malfunctions is found for the illumination control switch operation.
Diagnosis procedure
1.Check illumination control switch signal circuit
Check the illumination control switch signal circuit. Refer to mwi-56, "diagnosis procedure".
Is the inspection result normal? Yes >> go to 2.
No >> repair or replace harness or connector.
2.Check illumination control switch
Check the illumination control switch. Refer to mwi-56, "component inspection".
Is the inspection result normal? Yes >> replace combination meter. Refer to mwi-77, "removal and installation".
Ng >> replace illumination control switch. Refer to mwi-80, "removal and installation".
The steering switch (meter control switch) is inoperative
The oil pressure warning lamp does not turn onChild safety rear door lock
Child safety locks help prevent the rear doors
from being opened accidentally, especially when
small children are in the vehicle.
The child safety lock levers are located on the
edge of the rear doors.
When the lever is in the unlock position 2 , the
door can be opened from the outside ...
P0740 Torque converter
DTC Logic
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
Possible causes
P0740
TORQUE CONVERTER
(Torque Converter Clutch Circuit/
Open)
The TCM torque converter clutch solenoid
valve current monitor readi ...
Car phone or CB radio
When installing a CB, ham radio or car phone in
your vehicle, be sure to observe the following
precautions; otherwise, the new equipment may
adversely affect the engine control system and
other electronic parts.
WARNING
A cellular phone should not be used for
any purpose while dr ...