Nissan Sentra Service Manual: The ambient temperature display is incorrect

Nissan Sentra Service Manual / Driver information & multimedia / Meter, warning lamp & indicator / Symptom diagnosis / The ambient temperature display is incorrect

Description

The displayed outside air temperature is higher than the actual temperature.
The displayed outside air temperature is lower than the actual temperature.
Outside air temperature is not indicated.

Diagnosis procedure

1.Check ambient sensor signal circuit

Check the ambient sensor signal circuit. Refer to hac-63, "diagnosis procedure" (with auto a/c) or mwi-62, "diagnosis procedure" (without auto a/c).

Is the inspection result normal? Yes >> go to 2.

No >> repair or replace harness or connector.

2.Check ambient sensor

Check the ambient sensor. Refer to mwi-62, "component inspection".

Is the inspection result normal? Yes >> replace combination meter. Refer to mwi-77, "removal and installation".

No >> replace ambient sensor. Refer to hac-106, "removal and installation".

The parking brake release warning continues displaying, or does not display

Description The parking brake warning is displayed while driving the vehicle even though the parking brake is released. The parking brake warning is not displayed while driving the vehicle ...

The low washer fluid warning lamp does not turn on or off

Description The low washer fluid warning lamp is still illuminated even after washer fluid is added. The low washer fluid warning lamp is not illuminated even though the washer tank is emp ...

Other materials:

Symptom diagnosis
Engine does not start when intelligent key is inside of vehicle Description Engine does not start when push-button ignition switch is pressed while carrying intelligent key. Note: Check that vehicle is under the condition shown in вЂњconditions of vehicleвЂќ before starting diagnos ...

Steering column
Inspection STEERING COLUMN ASSEMBLY Check each part of steering column assembly for damage or other malfunctions. Replace entire steering column assembly if any parts are damaged. Measure steering column rotating torque using Tool. Replace steering column assembly if outside the ...

Fuel pressure
Work Procedure FUEL PRESSURE RELEASE 1.FUEL PRESSURE RELEASE With CONSULT Turn ignition switch ON. Perform вЂњFUEL PRESSURE RELEASEвЂќ in вЂњWORK SUPPORTвЂќ mode of вЂњENGINEвЂќ using CONSULT Start engine. After engine stalls, crank it two or three times to release ...