Nissan Sentra Owners Manual: Technical and consumer information
- Recommended fluids/lubricants and capacities
- Fuel recommendation
- Engine oil and oil filter recommendations
- Air conditioner system refrigerant and oil recommendations
- Specifications
- When traveling or registering your vehicle in another country
- Vehicle identification
- Vehicle identification number (VIN) plate
- F.M.V.S.S./C.M.V.S.S. certification label
- Emission control information label
- Installing front license plate
- Vehicle loading information
- Towing a trailer
- Uniform tire quality grading
- Emission control system warranty
- Reporting safety defects
- Readiness for inspection/maintenance (I/M) test
- Event Data Recorders (EDR)
- Owner’s Manual/Service Manual order information
Changing wheels and tires
Tire rotation
NISSAN recommends rotating the tires
every 7,500 miles (12,000 km).
See “Flat tire” in the “In case of emergency”
section of this manual for tire replacing
procedures. ...
Recommended fluids/lubricants and capacities
The following are approximate capacities. The actual refill capacities may
be slightly different. When refilling, follow the procedure
described in the “Maintenance and do-it-yourself” section ...
Other materials:
NISSAN vehicle immobilizer system
The NISSAN Vehicle Immobilizer system will not
allow the engine to start without the use of the
registered key.
If the engine fails to start using a registered key
(for example, when interference is caused by
another registered key, an automated toll road
device or automatic payment device o ...
Front door
Door assembly
Door assembly : removal and installation
CAUTION:
Use two people when removing or installing the front door assembly
due to its heavy weight.
When removing and installing front door assembly, support front
door using a suitable tool.
Do not use air tools or electric to ...
BCM branch line circuit
Diagnosis procedure
1.Check connector
Turn the ignition switch off.
Disconnect the battery cable from the negative terminal.
Check the terminals and connectors of the bcm for damage, bend and loose
connection (unit side and
connector side).
Is the inspection result normal?
YES > ...
