Nissan Sentra manuals

Nissan Sentra Service Manual: System description

Nissan Sentra Service Manual / Engine / Engine cooling system / System description

DESCRIPTION

Engine Cooling System Schematic

CVT Models
CVT Models

  1. Radiator
  2. Water inlet
  3. Reservoir tank
  4. Thermostat
  5. Engine oil cooler
  6. Thermostat housing
  7. Water pump
  8. Cylinder head

  9. Cylinder block
  10. Water control valve
  11. Water outlet
  12. Heater
  13. Electric throttle control actuator
  14. CVT oil warmer
  15. Heater thermostat
  1. Open
  2. Closed

CVT  models
CVT  models

  1. From heater thermostat
  2. From radiator
  3. To engine oil cooler
  4. To engine oil cooler
  5. To CVT oil warmer
  6. From heater core
  7. To heater core

M/T Models
M/T Models

  1. Radiator
  2. Water inlet
  3. Reservoir tank
  4. Thermostat
  5. Engine oil cooler
  6. Thermostat housing
  7. Water pump
  8. Cylinder head
  9. Cylinder block
  10. Water control valve
  11. Water outlet
  12. Heater
  13. Electric throttle control actuator
  1. Open
  2. Closed


  1. From heater thermostat
  2. From radiator
  3. To engine oil cooler
  4. To filler neck
  5. From heater core
  6. To heater core
Preparation
Special Service Tool The actual shape of the tools may differ from those illustrated here. Commercial Service Tool ...

Symptom diagnosis
OVERHEATING CAUSE ANALYSIS Troubleshooting Chart   Symptom Check items Cooling system parts malfunction Poor heat transfer Water pump malfunction Worn or lo ...

Other materials:

Description
NOTE: This vehicle is diagnosed using the CONSULT-III plus. When CONSULT is connected with a data link connector equipped on the vehicle side, it will communicate with the control unit equipped in the vehicle and then enable various kinds of diagnostic tests. Instrument lower panel LH ...

OIL PAN
Exploded View Transaxle assembly Oil pan gasket Magnet Oil pan Overflow tube Drain plug gasket Drain plug Oil pan fitting bolt : Always replace after every disassembly. : NВ·m (kg-m, ft-lb) : NВ·m (kg-m, it-lb) Removal and Installation REMOVAL Remove the en ...

U1010 Control unit (CAN)
Description Air bag diagnosis sensor performs self-tests on key ON. If CAN communication failure within control unit is detected, DTC is set. DTC Logic DTC DETECTION LOGIC CONSULT name DTC DTC detecting condition Repair order CAN CONTROL UNIT FAILURE U1010 CAN ...

© 2014-2025 Copyright www.nisentra.com