Nissan Sentra manuals

Nissan Sentra Service Manual: Symptom diagnosis

Push-button ignition switch does not operate

Description

Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnosis, and check each symptom.

Note:

The engine start function, door lock function, power distribution system, and nats-ivis/nvis in the intelligent key system are closely related to each other regarding control. The vehicle security function can operate only when the door lock and power distribution system are operating normally.

Conditions of vehicle (operating conditions)

Diagnosis procedure

1.Perform work support

Perform “inside ant diagnosis” on work support of “intelligent key”.

Refer to pcs-66, "intelligent key : consult function (bcm - intelligent key)".

>> Go to 2.

2.Perform self-diagnosis result

Perform self-diagnosis result of “bcm”.

Is dtc detected? Yes >> refer to bcs-49, "dtc index".

No >> go to 3.

3.Check push-button ignition switch

Check push-button ignition switch.

Refer to pcs-98, "component function check".

Is the operation normal? Yes >> go to 4.

No >> repair or replace malfunctioning parts.

4.Confirm the operation

Confirm the operation again.

Is the inspection normal? Yes >> check intermittent incident. Refer to gi-39, "intermittent incident".

No >> go to 1.

Dtc/circuit diagnosis
U1000 can comm circuit Description Refer to lan-7, "can communication system : system description". DTC Logic Dtc detection logic Note: U1000 can be set if a module harness was discon ...

Removal and installation
Push-button ignition switch Removal and installation Removal Remove the nats antenna amp. Refer to sec-135, "removal and installation" Remove the push-button ignition switch. I ...

Other materials:

Dtc/circuit diagnosis
Power supply and ground circuit Diagnosis Procedure Refer to LAN-7, "CAN COMMUNICATION SYSTEM : System Description". Vehicle security indicator Description DTC DETECTION LOGIC NOTE: U1000 can be set if a module harness was disconnected and reconnected, perhaps during a repair. Con ...

Wheel alignment
Inspection DESCRIPTION Measure the wheel alignment under unladen conditions. NOTE: “Unladen conditions” means that fuel, engine coolant, and lubricants are full. Spare tire, jack, hand tools and mats are in designated positions. PRELIMINARY Check the following: Tires for impro ...

P0963 Pressure control solenoid A
DTC Logic DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition Possible causes P0963 PC SOLENOID A (Pressure Control Solenoid A Control Circuit High) The line pressure solenoid valve current is 200 mA or less c ...

© 2014-2025 Copyright www.nisentra.com