Diagnosis Procedure
1.Check connector
Is the inspection result normal? Yes >> go to 2.
No >> repair the terminal and connector
2.Check harness for open circuit
Is the measurement value within the specification? YES >> GO TO 3.
NO >> Repair the steering angle sensor branch line.
3.Check power supply and ground circuit
Check the power supply and the ground circuit of the steering angle sensor. Refer to brc-44, "wiring diagram".
Is the inspection result normal? Yes (present error)>>replace the steering angle sensor. Refer to brc-113, "removal and installation".
Yes (past error)>>error was detected in the steering angle sensor branch line.
No >> repair the power supply and the ground circuit.
Towing a trailer
Do not tow a trailer with your vehicle.
Flat towing
Towing your vehicle with all four wheels on the
ground is sometimes called flat towing. This
method is sometimes used when towing a vehicle
behind a recreational vehicle, such as a motor
home.
CAUTION
Failure to follow these guidelines c ...
Basic inspection
Component inspection
Inspection
AFTER A COLLISION
WARNING:
Inspect all seat belt assemblies including retractors and attaching
hardware after any collision.
NISSAN/INFINITI recommends that all seat belt assemblies in use during a
collision be replaced
unless the collision was minor and t ...
Headlamp
Aiming adjustment
Preparation before adjusting
Before performing aiming adjustment, check the following:
Ensure all tires are inflated to correct pressure.
Place vehicle and screen on level surface.
Ensure there is no load in vehicle other than the driver (or equivalent
weight placed in ...