Nissan Sentra manuals

Nissan Sentra Service Manual: Strg branch line circuit

Diagnosis procedure

1.Check connector

  1. Turn the ignition switch off
  2. Disconnect the battery cable from the negative terminal.
  3. Check the terminals and connectors of the steering angle sensor for damage, bend and loose connection (unit side and connector side).

Is the inspection result normal? Yes >> go to 2.

No >> repair the terminal and connector.

2.Check harness for open circuit

  1. Disconnect the connector of steering angle sensor.
  2. Check the resistance between the steering angle sensor harness connector terminals.

Is the measurement value within the specification?


Is the measurement value within the specification? Yes >> go to 3.

No >> repair the steering angle sensor branch line.

3.Check power supply and ground circuit

Check the power supply and the ground circuit of the steering angle sensor. Refer to brc-44, "wiring diagram".

Is the inspection result normal? Yes (present error)>>replace the steering angle sensor. Refer to brc-113, "removal and installation".

Yes (past error)>>error was detected in the steering angle sensor branch line.

No >> repair the power supply and the ground circuit.

M&A branch line circuit
Diagnosis procedure 1.Check connector Turn the ignition switch off. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the combination meter for da ...

Bcm branch line circuit
Diagnosis procedure 1.Check connector Turn the ignition switch off. Disconnect the battery cable from the negative terminal. Check the terminals and connectors of the BCM for damage, bend and ...

Other materials:

Symptom diagnosis
The eco mode indicator lamp does not turn on Description The ECO mode indicator lamp does not turn ON when the ECO mode switch is operated. Diagnosis Procedure 1.Perform combination meter on board diagnosis Perform combination meter on board diagnosis. Refer to MWI-16, "Description" ...

Both side front fog lamps are not turned on
Description The front fog lamps do not turn on in any setting. Diagnosis procedure 1.Combination switch (lighting and turn signal switch) inspection Check the combination switch (lighting and turn signal switch). Refer to bcs-72, "symptom table" (with intelligent key system) or bcs- ...

OIL PAN
Exploded View Transaxle assembly Oil pan gasket Magnet Oil pan Overflow tube Drain plug gasket Drain plug Oil pan fitting bolt : Always replace after every disassembly. : NВ·m (kg-m, ft-lb) : NВ·m (kg-m, it-lb) Removal and Installation REMOVAL Remove the en ...

© 2014-2025 Copyright www.nisentra.com