Diagnosis Procedure
Regarding wiring diagram information, refer to mwi-28, "wiring diagram".
1.Check combination meter input signal
Is the inspection result normal? Yes >> inspection end.
No >> go to 2.
2.Check steering switch signal circuit
Is the inspection result normal? Yes >> inspection end.
No >> repair or replace harness or connector.
Component Inspection
1.Check steering switch
Check continuity between spiral cable terminals.
Is the inspection result normal? Yes >> inspection end.
No >> replace steering switch. Refer to st-10, "removal and installation".
Front drive shaft boot
Exploded View
(LH)
Circular clip
Dust shield
Slide joint housing
Snap ring
Spider assembly
Boot band
Boot
Shaft
Damper band
Dynamic damper
Circular clip
Joint sub-assembly
Wheel side
(RH) 6M/T
Joint sub-assembly
Circular clip
Boot band
Boot
Shaft
Dam ...
Anti-pinch system does not operate normally (driver side)
Diagnosis Procedure
1.CHECK POWER WINDOW AUTO OPERATION
Check AUTO operation when anti-pinch function does not operate.
Refer to PWC-67, "Diagnosis Procedure".
Is the inspection result normal?
YES >> INSPECTION END
NO >> GO TO 2.
2.REPLACE POWER WINDOW MAIN SWITCH
...
Using the system
Initialization
When the ignition switch is in the ON position,
NISSAN Voice Recognition is initialized, which
takes a few seconds. When completed, the system
is ready to accept voice commands. If
the button is pressed before the
initialization
completes, the system will announce: “Voice
...