Exploded View
Steering column assembly
Slide plates
lower shaft assembly
Removal and Installation
REMOVAL
CAUTION:
While removing the steering column assembly, do not unlock the tilt lever.
Do not impact on the axis when removing steering column assembly.
Be careful when removing steering column assembly from the vehicle because it is heavy.
Keep steering column assembly away from magnetic sources.
Do not disassemble steering column assembly, it is all one piece.
While removing the steering column assembly, do not move the steering gear assembly.
When removing the steering column assembly, be careful not to allow the lower shaft assembly to turn.
Set steering wheel to the straight-ahead position.
Place the tilt to the lowest level.
CAUTION:
Securely lock the tilt lever.
Remove instrument lower panel LH. Refer to IP-21, "Removal and Installation".
Remove driver air bag module. Refer to SR-12, "Removal and Installation".
Remove steering wheel. Refer to ST-10, "Removal and Installation".
Remove steering column cover. Refer to IP-16, "Removal and Installation".
Remove spiral cable. Refer to SR-16, "Removal and Installation".
Remove combination switch.
Disconnect key interlock cable (if equipped). Refer to TM-260, "Removal and Installation".
Remove hole cover (1).
Lower shaft assembly (2).
Remove lower side bolt of lower shaft assembly.
Disconnect each harness connector and harness clips installed to steering column assembly.
Disconnect EPS control unit harness connectors.
Remove the steering column assembly nuts.
CAUTION:
When removing the steering column assembly nuts, be careful not to drop the steering column assembly.
Remove the steering column.
Remove EPS control unit. Refer to STC-39, "Removal and Installation".
INSTALLATION
CAUTION:
Do not impact on the axis when removing steering column assembly.
When installing the steering column cover, check that the vehicle harness is not stuck in the cover.
Installation is in the reverse order of removal.
After tightening nut (A) of the steering column assembly, press in slide plate (outer and inner) (1) to tighten nut (B).
CAUTION:
Do not reuse slide plate.
The slide plate must be securely pressed in before tightening the nut of slide plate.
Lower shaft bolt is directional. Refer to ST-12, "Exploded View".
CAUTION:
Do not reuse lower shaft assembly bolt.
After installing steering column assembly, perform self-diagnosis with CONSULT to ensure correct operation.
Refer to STC-10, "CONSULT Function".
Perform inspection after installation. Refer to ST-7, "Inspection".
System
Warning chime system
Warning chime system : system diagram
Warning chime system : system description
Description
The buzzer for warning chime system is installed in the combination
meter.
The buzzer sounds when the combination meter receives a buzzer output
signal from the bcm.
Th ...
Diagnosis description : system readiness
test (SRT) code
System Readiness Test (SRT) code is specified in Service $01 of SAE J1979/ISO
15031-5.
As part of an enhanced emissions test for Inspection & Maintenance (I/M),
certain states require the status of
SRT be used to indicate whether the ECM has completed self-diagnosis of major
emission s ...
Exterior front
Engine hood
Windshield wiper and washer switch,
Windshield
Moonroof (if so equipped)
Power windows
Door locks, keyfob, keys, NISSAN
Intelligent Key® (if so equipped)
Mirrors
Tire pressure
Flat tire
Tire chains
Replacing bulbs
Headlight and turn signal switch, LED
he ...