Nissan Sentra Service Manual: Steering column
Inspection
STEERING COLUMN ASSEMBLY
-
Check each part of steering column assembly for damage or other malfunctions. Replace entire steering column assembly if any parts are damaged.
-
Measure steering column rotating torque using Tool. Replace steering column assembly if outside the specification.
Tool number (A) : ST3127S000 (J-25765-A)
Rotating torque : Refer to ST-18, "Steering Column".
-
Measure the length (L) as shown if vehicle has been involved in a minor collision. Replace steering column assembly if outside the specifications.
Steering column length (L) : Refer to ST-18, "Steering Column".
-
Check each part of steering column assembly for damage or other malfunctions. Replace if there are any abnormal conditions.
-
Check the steering wheel play, neutral position steering wheel, steering wheel turning force, and front wheel turning angle.Refer to ST-5, "Inspection"
-
Check tilt mechanism operating range and telescopic mechanism operating range as shown.
Tilt mechanism operating range (A) : Refer to ST-18, "Steering Column".
Telescopic mechanism operating range (B) : Refer to ST-18, "Steering Column".
Steering wheel
Inspection
CONDITION OF INSTALLATION
Check installation condition of power steering gear
assembly, front suspension, front drive shaft and steering
column.
Check if movement exists w ...
Steering gear and linkage
Inspection
INSPECTION AFTER DISASSEMBLY
BOOT
Check boot for cracks. Replace if any damage is found.
STEERING GEAR ASSEMBLY HOUSING
Check steering gear assembly housing for damage ...
Other materials:
Service data and specifications (SDS)
Wheel Alignment (Unladen*1)
UNITED STATES and CANADA
*1: Fuel, engine coolant, and lubricants are full. Spare tire, jack, hand
tools, and mats are in designated positions.
*2: The difference when assuming the (LH) side is the standard.
Ball Joint
Wheelarch Height (Unladen*)
UNITED S ...
Refrigerant pressure sensor
Component Function Check
1.CHECK REFRIGERANT PRESSURE SENSOR OVERALL FUNCTION
Start engine and warm it up to normal operating temperature.
Turn A/C switch and blower fan switch ON.
Check the voltage between ECM harness connector terminals.
Is the inspection result normal?
YES >> ...
Power supply and ground circuit
BCM (BODY CONTROL SYSTEM) (WITH INTELLIGENT KEY SYSTEM)
BCM (BODY CONTROL SYSTEM) (WITH INTELLIGENT KEY SYSTEM) : Diagnosis Procedure
Regarding Wiring Diagram information, refer to BCS-51, "Wiring Diagram".
1.Check fuses and fusible link
Check that the following fuses and fusible link ...
