Nissan Sentra manuals

Nissan Sentra Owners Manual: Starting the engine (models with NISSAN Intelligent Key® system)

Nissan Sentra Owners Manual / Starting and driving / Starting the engine (models with NISSAN Intelligent Key® system)

  1. Apply the parking brake.
  2. Continuously Variable Transmission: Move the shift lever to P (Park) or N (Neutral).

    P (Park) is recommended.

    The starter is designed not to operate if the shift lever is in any of the driving positions.

    Manual Transmission: Move the shift lever to N (Neutral). Depress the clutch pedal to the floor.

    The starter is designed not to operate unless the clutch pedal is fully depressed.

  3. Push the ignition switch to the ON position.

    Depress the brake pedal and the clutch pedal (if so equipped) and push the ignition switch to start the engine.

    To start the engine immediately, push and release the ignition switch while depressing the brake pedal with the ignition switch in any position.

CAUTION

Do not operate the starter for more than 15 seconds at a time. If the engine does not start, push the ignition switch to the OFF position and wait 10 seconds before cranking again, otherwise the starter could be damaged.

  1. Warm-up

Allow the engine to idle for at least 30 seconds after starting. Do not race the engine while warming it up. Drive at moderate speed for a short distance first, especially in cold weather. In cold weather, keep the engine running for a minimum of 2 - 3 minutes before shutting it off. Starting and stopping the engine over a short period of time may make the vehicle more difficult to start.

  1. To stop the engine, shift the shift lever to the P (Park) position or to N (Neutral) and apply the parking brake (M/T) and push the ignition switch to the OFF position.

NOTE:

Care should be taken to avoid situations that can lead to potential battery discharge and potential no-start conditions such as:

  1. Installation or extended use of electronic accessories that consume battery power when the engine is not running (Phone chargers, GPS, DVD players, etc.).
  2. Vehicle is not driven regularly and/or only driven short distances. In these cases, the battery may need to be charged to maintain battery health.
Starting the engine
Apply the parking brake. CVT model: Move the shift lever to P (Park) or N (Neutral). P (Park) is recommended. The shift lever cannot be moved out of P (Park) and into any of the other gea ...

Driving the vehicle
...

Other materials:

Slip indicator lamp
Component Function Check 1.CHECK SLIP INDICATOR LAMP FUNCTION Check that slip indicator lamp in combination meter turns ON for approximately 2 seconds after ignition switch is turned ON. Is the inspection result normal? YES >> Inspection End. NO >> Proceed to diagnosis proce ...

Unit removal and installation
TRANSMISSION ASSEMBLY Exploded View Transaxle assembly O-ring CVT fluid charging pipe CVT fluid charging pipe cap Tightening must be done following the installation procedure. Refer to TM-283, "Removal and Installation". : Always replace after every disassemb ...

A-bag branch line circuit
Diagnosis procedure Warning: Always observe the following items for preventing accidental activation. Before servicing, turn ignition switch off, disconnect battery negative terminal, and wait 3 minutes or more. (To discharge backup capacitor.) Never use unspecified tester or other me ...

© 2014-2025 Copyright www.nisentra.com