Nissan Sentra Owners Manual: Starting and driving
- Precautions when starting and driving
- Exhaust gas (carbon monoxide)
- Three-way catalyst
- Tire Pressure Monitoring System (TPMS)
- Avoiding collision and rollover
- Off-road recovery
- Rapid air pressure loss
- Drinking alcohol/drugs and driving
- Ignition switch (if so equipped)
- Continuously Variable Transmission (CVT) (if so equipped)
- Manual transmission (if so equipped)
- Key positions
- NISSAN vehicle immobilizer system
- Push-Button Ignition Switch (if so equipped)
- Operating range
- Push-button ignition switch positions
- Emergency engine shut off
- NISSAN Intelligent Key® battery discharge
- NISSAN vehicle immobilizer system
- Before starting the engine
- Starting the engine
- Starting the engine (models with NISSAN Intelligent Key® system)
- Driving the vehicle
- Parking brake
- SPORT mode switch
- ECO mode switch
- Cruise control (if so equipped)
- Break-in schedule
- Fuel efficient driving tips
- Increasing fuel economy
- Parking/parking on hills
- Power steering
- Brake system
- Vehicle Dynamic Control (VDC) system
- Cold weather driving
Troubleshooting guide
The system should respond correctly to all voice
commands without difficulty. If problems are encountered,
follow the solutions given in this guide
for the appropriate error. Where the solutions ar ...
Precautions when starting and driving
WARNING
Do not leave children or adults who
would normally require the assistance
of others alone in your vehicle. Pets
should also not be left alone. They
could accidentall ...
Other materials:
Basic inspection
Inspection and adjustment
Additional service when replacing control unit (bcm)
ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT (BCM) : Description
Before replacement
When replacing bcm, save or print current vehicle specification with consult
configuration before replacement.
Note:
If “B ...
Precaution for work
When removing or disassembling each component, be careful not to damage
or deform it. If a component
may be subject to interference, be sure to protect it with a shop cloth.
When removing (disengaging) components with a screwdriver or similar
tool, be sure to wrap the component
with a ...
Rear drum brake
Exploded View
Cap
Bleeder valve
Piston
Spring
Boot
Piston cup
Wheel cylinder
Apply rubber grease
Apply PBC (Poly Butyl Cuprysil)
grease or silicone-based grease
Apply brake fluid
Disassembly and Assembly
DISASSEMBLY
Remove the boot from wheel cylinder. Refer t ...
