Nissan Sentra Service Manual: Service data and specifications (sds)
General Specification
Drive Belt
Spark Plug
*:Always check with the Parts Department for the latest parts information.
Exhaust Manifold
Camshaft
VALVE LIFTER
VALVE CLEARANCE
*: Approximately 80В°C (176В°F)
AVAILABLE VALVE LIFTER
*:Always check with the Parts Department for the latest parts information.
Cylinder Head
VALVE DIMENSIONS
VALVE GUIDE
VALVE SEAT
*1: Diameter made by intersection point of conic angles “α1” and “α2”
*2: Diameter made by intersection point of conic angles “α2” and “α3”
*3: Machining data
VALVE SPRING
Cylinder Block
AVAILABLE PISTON
*:Always check with the Parts Department for the latest parts information.
PISTON RING
PISTON PIN
CONNECTING ROD
*: After installing in connecting rod
CRANKSHAFT
*: Total indicator reading
Connecting Rod Bearing
CONNECTING ROD BEARING GRADE TABLE
*:Always check with the Parts Department for the latest parts information.
UNDERSIZE TABLE
CONNECTING ROD BEARING OIL CLEARANCE
Main Bearing
MAIN BEARING GRADE TABLE (ALL JOURNALS)
*:Always check with the Parts Department for the latest parts information.
UNDERSIZE TABLE
MAIN BEARING OIL CLEARANCE
How to select piston and bearing
Description
Selection points
Selection parts
Selection items
Selection methods
Between cylinder block and
crankshaft
Main bearing
Main bearing grade (bearing
thi ...
Other materials:
6M/T
6M/T : Exploded View (LH)
Circular clip
Dust shield
Slide joint housing
Snap ring
Spider assembly
Boot band
Boot
Shaft
Damper band
Dynamic damper
Circular clip
Joint sub-assembly
Wheel side
6M/T : Disassembly and Assembly (LH)
DISASSEMBLY (WHEEL SIDE)
CAUTION:
...
Basic inspection
Component inspection
Inspection
AFTER A COLLISION
WARNING:
Inspect all seat belt assemblies including retractors and attaching
hardware after any collision.
NISSAN/INFINITI recommends that all seat belt assemblies in use during a
collision be replaced
unless the collision was minor and t ...
Additional service when removing battery negative terminal
Description
When the battery negative terminal is disconnected, the initialization is
necessary for normal operation of
power window system.
CAUTION:
The following specified operations can not be performed under the
non-initialized condition.
Auto-up operation
Anti-pinch function
Wo ...
