Nissan Sentra Service Manual: Service

Nissan Sentra Service Manual / Restraints / SRS airbag control system / Precaution / Service

Never use electrical test equipment to check SRS circuits unless instructed to in this Service Manual.
Before servicing the SRS, turn power switch OFF, disconnect battery negative terminal and wait 3 minutes or more.
For approximately 3 minutes after the cables are removed, it is still possible for the air bag and seat belt pretensioner to deploy. Therefore, never work on any SRS connectors or wires until at least 3 minutes have passed.
Diagnosis sensor unit must always be installed with their arrow marks вЂњ⇐вЂќ pointing towards the front of the vehicle for proper operation. Also check diagnosis sensor unit for cracks, deformities or rust before installation and replace as required.
The spiral cable must be aligned with the neutral position since its rotations are limited. Never turn steering wheel and column after removal of steering gear.
Handle air bag module carefully. Always place driver and front passenger air bag modules with the pad side facing upward and seat mounted front side air bag module standing with the stud bolt side facing down.
Conduct self-diagnosis to check entire SRS for proper function after replacing any components.
After air bag inflates, the front instrument panel assembly should be replaced if damaged.
Always replace instrument panel pad following front passenger air bag deployment.
Never solder the harness when making repairs. Check that harness is not pinched and that there is no contact with other components
Never allow harness to come in contact with oil, grease, waste oil, or water.
Never insert foreign materials, such as a screwdriver, into the harness connector. (This is to prevent accidental activation caused by static electricity.)
Always use CONSULT or SRS air bag warning lamp to perform the circuit diagnosis. (Never use an electric tester such as a circuit tester.)

Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER"

The Supplemental Restraint System such as вЂњAIR BAGвЂќ and вЂњSEAT BELT PRE-TENSIONERвЂќ, used along with a front seat belt, helps to reduce the risk or severity of injury to the dri ...

System description

...

Other materials:

Basic inspection
Diagnosis and repair work flow Work flow Overall sequence Detailed flow 1.Get information for symptom Get detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurs). Check operation condition of the component o ...

Service data and specifications (sds)
General Specification Drive Belt Spark Plug *:Always check with the Parts Department for the latest parts information. Exhaust Manifold Camshaft VALVE LIFTER VALVE CLEARANCE *: Approximately 80В°C (176В°F) AVAILABLE VALVE LIFTER *:Always check with the P ...

P1212 TCS Communication line
Description This CAN communication line is used to control the smooth engine operation during the TCS operation. Pulse signals are exchanged between ECM and вЂњABS actuator and electric unit (control unit)вЂќ. Be sure to erase the malfunction information such as DTC not only for вЂ� ...