Nissan Sentra Service Manual: Seat belt buckle switch signal circuit
Description
Transmits a seat belt buckle switch lh (driver seat) signal to the combination meter
Component function check
1. Check combination meter input signal
Select data monitor for meter/m&a and check the buckle sw monitor value.
YES >> Inspection End.
NO >> Refer to WCS-29, "Diagnosis Procedure".
Diagnosis procedure
Regarding wiring diagram information, refer to wcs-17, "wiring diagram".
1.Check combination meter input signal
- Turn ignition switch on.
- Check voltage between combination meter harness connector m24 terminal 9 and ground.
Is the inspection result normal? Yes >> replace combination meter. Refer to mwi-77, "removal and installation".
No >> go to 2.
2.Check seat belt buckle switch circuit
- Turn ignition switch OFF.
- Disconnect combination meter harness connector m24 and seat belt buckle switch lh (driver seat) harness connector b16.
- Check continuity between combination meter harness connector m24 terminal 9 and seat belt buckle switch lh (driver seat) harness connector b16 terminal 1.
- Check continuity between combination meter harness connector m24 terminal 9 and ground.
Is the inspection result normal?
Yes >> go to 3.
No >> repair or replace harness or connector.
3.Check seat belt buckle switch ground circuit
Check continuity between seat belt buckle switch lh (driver seat) harness connector b16 terminal 2 and ground.
Is the inspection result normal? Yes >> check the seat belt buckle switch. Refer to wcs-30, "component inspection".
No >> repair or replace harness or connector.
Component inspection
1. Check seat belt buckle switch
- Turn ignition switch off.
- Disconnect the seat belt buckle switch lh (driver seat).
- Check continuity between the seat belt buckle switch lh (driver seat) terminals 1 and 2.
Is the inspection result normal? Yes >> inspection end.
No >> replace the seat belt buckle switch lh (driver seat). Refer to sr-32, "removal and installation".
Meter buzzer circuit
Description
The buzzer for warning chime system is installed in the combination
meter.
The combination meter sounds the alarm buzzer based on the signals
transmitted from various units.
...
Other materials:
Engine room cover
Exploded View
Engine room cover
Mounting rubber (Black)
Mounting rubber (Gray)
Removal and Installation
REMOVAL
CAUTION:
Do not damage or scratch engine room cover when installing or removing.
Remove engine room cover by pulling straight up to release mounting rubber.
INSTALLATI ...
Connecting Procedure
NOTE:
The connecting procedure must be performed
when the vehicle is stationary. If the
vehicle starts moving during the procedure,
the procedure will be cancelled.
Press the [ ] button on the
control
panel.
Touch the “Settings” key.
Touch the “Phone & Bluetooth” ke ...
Periodic maintenance
CVT FLUID
Inspection
FLUID LEAKAGE
Check transaxle surrounding area (oil seal and plug etc.) for fluid
leakage.
If anything is found, repair or replace damaged parts and adjust
CVT fluid level. Refer to TM-251, "Adjustment".
Replacement
CVT fluid : Refer to TM-288, & ...
