Nissan Sentra Service Manual: S terminal circuit
Description
The output voltage of the generator is controlled by the IC regulator at terminal “S” detecting the input voltage from battery.
The “S” terminal circuit detects the battery voltage to adjust the generator output voltage with the IC voltage regulator.
Diagnosis procedure
Regarding wiring diagram information. Refer to chg-9, "wiring diagram".
1.Check “s” terminal connection
- Turn ignition switch OFF.
- Check if “s” terminal is clean and tight.
Is the inspection result normal? Yes >> go to 2.
No >> repair “s” terminal connection. Confirm repair by performing complete charging system test using exp-800 ni or gr8-1200 ni (if available). Refer to the applicable instruction manual for proper testing procedures.
2.Check “s” terminal circuit
Check voltage between generator harness connector and ground.
Is the inspection result normal? Yes >> refer to chg-14, "work flow (with exp-800 ni or gr8-1200 ni)" or chg-17, "work flow (without exp-800 ni or gr8-1200 ni)".
No >> check harness for open between generator and fuse.
L terminal circuit (short)
Description
The terminal “l” circuit controls the charge warning lamp. The charge warning
lamp turns on when the ignition
switch is set to on or start. When the generator is providing s ...
Symptom diagnosis
Charging system
Symptom table
...
Other materials:
P0122, P0123 TP Sensor
DTC Logic
DTC DETECTION LOGIC
NOTE:
If DTC P0122 or P0123 is displayed with DTC P0643, first perform the
trouble diagnosis for DTC P0643.
Refer to EC-353, "DTC Logic".
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
Possible caus ...
P1212 TCS Communication line
Description
This CAN communication line is used to control the smooth engine operation
during the TCS operation. Pulse
signals are exchanged between ECM and “ABS actuator and electric unit (control
unit)”.
Be sure to erase the malfunction information such as DTC not only for Ð²Ð‚Ñ ...
On board diagnosis function
ON BOARD DIAGNOSIS ITEM
The on board diagnostic system has the following functions.
Diagnostic test mode
Function
Bulb check
MIL can be checked.
SRT status
ECM can read if SRT codes are set.
Malfunction warning
If ECM detects a malfunction, it illumina ...
