Nissan Sentra Service Manual: Removal and installation

Wheel alignment

Inspection PRELIMINARY INSPECTION WARNING: Always adjust the wheel alignment with the vehicle on a flat surface. NOTE: If the wheel alignment is out of specification, inspect and replace any d ...

Front coil spring and strut

Exploded View Piston rod lock nut Strut mount insulator Strut mount bearing Bound bumper Coil spring Lower rubber seat Strut Steering knuckle Front Removal and Installation ...

Other materials:

P0138 HO2S2
DTC Logic DTC DETECTION LOGIC The heated oxygen sensor 2 has a much longer switching time between rich and lean than the air fuel ratio (A/ F) sensor 1. The oxygen storage capacity of the three way catalyst (manifold) causes the longer switching time. MALFUNCTION A To judge the malfunction ...

Harness connector
Description Harness connector (tab-locking type) The tab-locking type connectors help prevent accidental looseness or disconnection. The tab-locking type connectors are disconnected by pushing or lifting the locking tab(s). Refer to the figure below. Refer to the next page for desc ...

CONSULT Data Link Connector (DLC) Circuit
Inspection procedure If the CONSULT cannot diagnose the system properly, check the following items. Symptom Check item CONSULT cannot access any system. CONSULT DLC power supply circuit (Terminal 8 and 16) and ground circuit (Terminal 4 and 5) ...