Nissan Sentra Service Manual: Removal and installation
Eco mode switch
Removal and installation
Removal
- Remove instrument lower panel LH. Refer to IP-21, "Removal and Installation".
- Remove ECO mode switch.
Installation
Installation is in the reverse order of removal.
Symptom diagnosis
The eco mode indicator lamp does not turn on
Description
The ECO mode indicator lamp does not turn ON when the ECO mode switch is
operated.
Diagnosis Procedure
1.Perform combination meter on boa ...
Sport mode (m/t)
...
Other materials:
DTC/Circuit diagnosis
U0073 COMMUNICATION BUS A OFF
DTC Logic
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
Possible causes
U0073
COMM BUS A OFF
(Control Module Communication
Bus A Off)
TCM communication blockage lasts for 2 sec ...
B0092 Rear side air bag satellite sensor LH
Description
DTC B0092 REAR SATELLITE SENSOR LH
The rear side air bag satellite sensor LH is wired to the air bag diagnosis
sensor unit. The air bag diagnosis
sensor unit will monitor the rear side air bag satellite sensor LH for internal
failures and its circuits for communication
errors.
...
Refrigerant pressure sensor
Component Function Check
1.CHECK REFRIGERANT PRESSURE SENSOR OVERALL FUNCTION
Start engine and warm it up to normal operating temperature.
Turn A/C switch and blower fan switch ON.
Check the voltage between ECM harness connector terminals.
Is the inspection result normal?
YES >> ...
